- Zeolite 4A supported CdS/g-C3N4 type-II heterojunction: A novel visible-light-active ternary nanocomposite for potential photocatalytic degradation of cefoperazone
-
The CdS/g-C3N4 heterojunction photocatalyst supported on 4A zeolite was successfully synthesized using a simple chemical precipitation method. The physicochemical characteristics of the as-prepared ternary composite were assessed using X-Ray diffraction (XRD), field emission- scanning electron microscopy (FE-SEM), energy dispersive X-Ray (EDX), transmission electron microscopy (TEM), N2 adsorption–desorption, differential reflectance spectroscopy (UV–Vis-DRS), and photoluminescence (PL) techniques. The results confirmed the successful synthesis of the CdS/g-C3N4/4AZ nanocomposite and introduction of the CdS and g-C3N4 on the substrate of 4A zeolite. Cefoperazone (CFP) antibiotic was tested as the model pollutant to assess the photocatalytic performance of the synthesized nanocomposite under visible light irradiation. The response surface methodology (RSM) and artificial neural network (ANN) showed desirable reasonability for the prediction of the CFP degradation efficiency. More than 93% of CFP with a concentration of 17 mg L-1 degraded in the presence of the 0.4 g L-1 of the catalyst at pH of 9 after 80 min treatment time (RSM-based optimization results). The pH of the solution, irradiation time, catalyst dosage, and the initial concentration of the CFP affected degradation efficiency with a percentage impact of 37, 29, 19, and 15 %, respectively (ANN-based modeling results). The addition of 1 mM of isopropanol, benzoquinone, and sodium oxalate reduced the CFP degradation efficiency from 93.23% to 85.18, 41.16, and 32.47%, respectively, proving the decisive role of the °O2– and h+ in the photodegradation process. The kinetic studies indicated the following of the process from the Langmuir-Hinshelwood's pseudo-first-order model (kapp = 3.71 × 10-2 min?1). The structure of the identified by-products using GC-MS analysis confirmed that CFP mainly decomposed through the cleavage of C-S, C-N, and N-N bonds. Moreover, the formation of the aliphatic compounds and carboxylic acids as by-products confirmed nearly complete mineralization of the CFP to non-toxic products.
- AttariKhasraghi, Naime,Behnajady, Mohammad A.,Mehrizad, Ali,Modirshahla, Nasser,Zare, Karim
-
-
- Highly selective asymmetric Rh-catalyzed hydroformylation of heterocyclic olefins
-
A small family of new chiral hybrid, diphosphorus ligands, consisting of phosphine-phosphoramidites L1 and L2 and phosphine-phosphonites L3a-c, was synthesized for the application in Rh-catalyzed asymmetric hydroformylation of heterocyclic olefins. High-pressure (HP)-NMR and HP-IR spectroscopy under 5-10 bar of syngas has been employed to characterize the corresponding catalyst resting state with each ligand. Indole-based ligands L1 and L2 led to selective ea coordination, while the xanthene derived system L3c gave predominant ee coordination. Application of the small bite-angle ligands L1 and L2 in the highly selective asymmetric hydroformylation (AHF) of the challenging substrate 2,3-dihydrofuran (1) yielded the 2-carbaldehyde (3) as the major regioisomer in up to 68% yield (with ligand L2) along with good ees of up to 62%. This is the first example in which the asymmetric hydroformylation of 1 is both regio- and enantioselective for isomer 3. Interestingly, use of ligand L3c in the same reaction completely changed the regioselectivity to 3-carbaldehyde (4) with a remarkably high enantioselectivity of 91%. Ligand L3c also performs very well in the Rh-catalyzed asymmetric hydroformylation of other heterocyclic olefins. Highly enantioselective conversion of the notoriously difficult substrate 2,5-dihydrofuran (2) is achieved using the same catalyst, with up to 91% ee, concomitant with complete regioselectivity to the 3-carbaldehyde product (4) under mild reaction conditions. Interestingly, the Rh-catalyst derived from L3c is thus able to produce both enantiomers of 3-carbaldehyde 4, simply by changing the substrate from 1 to 2. Furthermore, 85% ee was obtained in the hydroformylation of N-acetyl-3-pyrroline (5) with exceptionally high regioselectivities for 3-carbaldehyde 8Ac (>99%). Similarly, an ee of 86% for derivative 8Boc was accomplished using the same catalyst system in the AHF of N-(tert-butoxycarbonyl)-3-pyrroline (6). These results represent the highest ees reported to date in the AHF of dihydrofurans (1, 2) and 3-pyrrolines (5, 6).
- Chikkali, Samir H.,Bellini, Rosalba,De Bruin, Bas,Van Der Vlugt, Jarl Ivar,Reek, Joost N. H.
-
supporting information; experimental part
p. 6607 - 6616
(2012/06/15)
-
- ORIENTATION OF CARBOXYLATION REACTION BY CONTACT GLOW DISCHARGE ELECTROLYSIS
-
The carboxylation reaction of aliphatic amines and cyclic imines in aqueous formic acid by contact glow discharge electrolysis (CDGE) was studied and the orientation of the carboxylation reaction was investigated.It was found that orientation of the reaction was controlled by the effect of the charged and uncharged nitrogen atom.
- Terasawa, Jun-ichi,Harada, Kaoru
-
-