P. Babiak et al. / Journal of Fluorine Chemistry 129 (2008) 397–401
401
´
¨
[3] (a) L.E. Kiss, I. Kovesdi, J. Rabai, J. Fluorine Chem. 108 (2001) 95–109;
(b) F.T.T. Huque, K. Jones, R.A. Saunders, J.A. Platts, J. Fluorine Chem.
115 (2002) 119–128;
mixture was warmed up to room temperature over 30 min and
then the crude product was distilled under reduced pressure.
The pure product was obtained as a colorless liquid in 62–79%
yield (>98% GC purity) by washing several times with water to
remove traces of alcohol and drying with anhydrous MgSO4.
MS and 1H NMR spectra were in good agreement with
published data.
´
(c) P.R. Duchowicz, F.M. Fernandez, E.A. Castro, J. Fluorine Chem. 125
(2004) 43–48;
(d) E. de Wolf, P. Ruelle, J. van den Broeke, B.-J. Deelman, G. van Koten,
J. Phys. Chem. B 108 (2004) 1458–1466.
[4] (a) R.L. Scott, J. Am. Chem. Soc. 70 (1948) 4090–4093;
(b) J.H. Hildebrand, D.R.F. Cochran, J. Am. Chem. Soc. 71 (1949) 22–25;
(c) J.H. Hildebrand, B.B. Fisher, H.A. Benesi, J. Am. Chem. Soc. 72
(1950) 4348–4351;
4.3. Calculations of miscibility temperatures
(d) G.S. Bernardo-Gil, L.J.S. Soares, J. Chem. Eng. Data 32 (1987) 327–
329;
All calculations were carried out within the framework of
DFT using B-LYP [18] functional and TZVPP basis set [19].
The calculations were performed using Turbomole 5.8 program
[20]. In COSMOtherm program, default parameters were used
in all cases. Calculated Tm (PFD) values refer to cis isomer,
(e) L.P. Barthel-Rosa, J.A. Gladysz, Coord. Chem. Rev. 190–192 (1999)
587–605.
[5] (a) A.F.M. Barton, Chem. Rev. 75 (1975) 731–753;
(b) A.F.M. Barton, CRC Handbook of Solubility Parameters and Other
Cohesion Parameters, CRC Press, Boca Raton, FL, 1983.
[6] (b) P. Mukerjee, C. Ramachandran, R.A. Pyter, J. Phys. Chem. 86 (1982)
3189–3197;
Tm (PDF) values for trans isomer were found to be very similar.
(b) J.L. Fulton, J.P. Blitz, J.M. Tingey, R.D. Smith, J. Phys. Chem. 93
(1989) 4198–4204;
4.4. Determinations of miscibility temperatures
(c) H. Hiemstra, H. Wynberg, J. Am. Chem. Soc. 103 (1981) 417–430.
[7] F. Eckert, A. Klamt, COSMOtherm, Version C2.1, Release 01.05,
COSMOlogic Gmbh & Co. KG, Leverkusen, Germany, 2005.
[8] (a) A. Klamt, J. Phys. Chem. 99 (1995) 2224–2235;
(b) A. Klamt, F. Eckert, Fluid Phase Equilib. 172 (2000) 43–72;
(c) F. Eckert, A. Klamt, AIChE J. 48 (2002) 369–385.
[9] (a) A. Klamt, G. Schuurmann, J. Chem. Soc. Perkin Trans. 2 (1993) 799–
805;
Mixture of organic and perfluorocarbon solvent (0.5 ml
each) was placed in a glass vial and sealed. The vial was
equilibrated for 5 min in a temperature controlled water bath
and periodically shaken. The temperature of the bath was
increased by 1 8C (the vial was equilibrated for another 5 min)
until the formation of one phase system. In all cases sharp phase
change over ꢁ1 8C was observed.
¨
(b) A. Schafer, A. Klamt, D. Sattel, J.C.W. Lohrenz, F. Eckert, Phys.
Chem. Chem. Phys. 2 (2000) 2187–2193.
[10] P. Politzer, P. Lane, M.C. Concha, Y. Ma, J.S. Murray, J. Mol. Model. 13
(2007) 305–311.
4.5. Solubility measurements
[11] (a) C. Laurence, P. Nicolet, M.T. Dalati, J.-L. Abboud, R. Notario, J.
Phys. Chem. 98 (1994) 5807–5816;
(b) N. Gee, K. Shinsana, J.-P. Dodelet, G.R. Freeman, J. Chem. Thermo-
dyn. 18 (1986) 221–234;
Mixture of organic and perfluorocarbon solvent (0.2 ml
each) was manually shaken for 30 s and then equilibrated at
25 8C or À20 8C for at least 30 min. A portion (10 ml) was
taken from each phase, diluted with diethyl ether (1 ml) and
analyzed using GC–MS. In case of measuring solubilities of
perfluorocarbons with diethyl ether, dibutyl ether was used for
dilution. A four point calibration curve was made for each
solvent. The solubility was calculated from the concentration
ratio of each compound and is reported as an average of three
separate measurements.
(c) H. Farber, S. Petrucci, J. Phys. Chem. 85 (1981) 1396–1401.
[12] (a) E.L. Krasnykh, S.V. Levanova, S.Y. Karaseva, I.N. Kirgizova, R.M.
Varushchenko, A.I. Druzhinina, L.L. Pashchenko, Pet. Chem. 45 (2005)
92–95;
(b) V. Majer, Z. Wagner, V. Svoboda, V. Cadek, J. Chem. Thermodyn. 12
(1980) 387–391;
(c) S.P. Verevkin, E.L. Krasnykh, T.V. Vasiltsova, A. Heintz, J. Chem.
Eng. Data 48 (2003) 591–599;
(d) W.V. Steele, R.D. Chirico, S.E. Knipmeyer, A. Nguyen, N.K. Smith, J.
Chem. Eng. Data 41 (1996) 1285–1302;
(e) D.M. McEachern, J.E. Kilpatrick, J. Chem. Phys. 41 (1964) 3127–
3130;
Acknowledgments
(f) M.G. Voronkov, L.A. Zhagata, Zh. Org. Khim. 4 (1968) 768–771.
[13] D.R. Lide, CRC Handbook of Chemistry and Physics, 88th edition, CRC
Press, London, 2007.
This work was supported by Research Plan AVZ40550506
from the Academy of Sciences of the Czech Republic and
program LC512 from the Ministry of Education of the Czech
Republic.
[14] I.H. Peng, C.H. Tu, J. Chem. Eng. Data 49 (2004) 876–880.
[15] (a) M. Singliar, V. Macho, M. Kavala, Collect. Czech. Chem. Commun.
47 (1982) 1979–1987;
´
´
(b) J. Cidlinsky, J. Polak, Collect. Czech. Chem. Commun. 34 (1969)
1317–1321.
References
[16] H.N. Huang, D.F. Persico, R.J. Lagow, L.C. Clark, J. Org. Chem. 53
(1988) 78–85.
´
[17] J.J.J. Juliette, D. Rutherford, I.T. Horvath, J.A. Gladysz, J. Am. Chem.
[1] (a) P. Kirsch, Modern Fluoroorganic Chemistry, Wiley-VCH, Weinheim,
2004, pp. 8–16;
Soc. 121 (1999) 2696–2704.
(b) G. Sandford, Tetrahedron 59 (2003) 437–454.
´ ´
[2] (a) I.T. Horvath, J. Rabai, Science 266 (1994) 72–75;
[18] (a) A.D. Becke, Phys. Rev. A 38 (1988) 3098–3100;
(b) C.T. Lee, W.T. Yang, R.G. Parr, Phys. Rev. B 37 (1988) 785–789.
[19] A. Scha¨fer, C. Huber, R. Ahlrichs, J. Chem. Phys. 100 (1994) 5829–5835.
´
(b) I.T. Horvath, Acc. Chem. Res. 31 (1998) 641–650;
´
(c) J.A. Gladysz, D.P. Curran, I.T. Horvath, Handbook of Fluorous
¨ ¨ ¨
[20] R. Ahlrichs, M. Bar, M. Haser, H. Horn, C. Kolmel, Chem. Phys. Lett. 162
Chemistry, Wiley-VCH, Weinheim, 2004.
(1989) 165–169.