10.1002/cssc.202001117
ChemSusChem
FULL PAPER
Subramanian, Y. Song, D. Kim, C. T. Yavuz, ACS Energy Lett. 2020,
10.1021/acsenergylett.0c00406.
monochromatized Al Kα (hν = 1486.6 eV) as the excitation
source.
[6]
[7]
A. Duval, L. Averous, ACS Sustain. Chem. Eng. 2017, 5, 7334-7343.
I. A. Shkrob, Y. Zhu, T. W. Marin, D. Abraham, J. Phys. Chem. C 2013,
117, 19255-19269.
Synthesis of crosslink-polymer catalyst.
[8]
[9]
C. Martin, G. Fiorani, A. W. Kleij, ACS Catal. 2015, 5, 1353-1370.
C. Federsel, R. Jackstell, M. Beller, Angew. Chem. Int. Ed. 2010, 49,
6254-6257.
The synthetic scheme is shown in Scheme 2. Take the cross-
linked bifunctional P-Cm3Lm1Nm2 as an example, Nm2 (2 g, 7.3
mmol), Lm1 (1.14 g, 7.3 mmol), Cm3 (4.46 g, 9.1 mmol), and TPO
(5 wt%) were dissolved in 10 mL of dichloroethane. Then the
mixture was transferred into a glass petri dish and placed
directly under a UV lamp (36 W, 365 nm) for 10 min. After
evaporation recovery of the solvent, a light yellow solid was
obtained. Under the same preparation method, control catalyst
systems P-Cm3Nm2 and P-Cm3Lm1 were obtained with Cm3 by Nm2
and Lm1, respectively.
[10] a) J. A. Castro-Osma, K. J. Lamb, M. North, ACS Catal. 2016, 6, 5012-
5025; b) A. Decortes, A. M. Castilla, A. W. Kleij, Angew. Chem. Int. Ed.
2010, 49, 9822-9837; c) W. Clegg, R. W. Harrington, M. North, R.
Pasquale, Chem.-Eur. J. 2010, 16, 6828-6843.
[11] a) M. L. Ding, H. L. Jiang, ACS Catal. 2018, 8, 3194-3201; b) L. G. Ding,
B. J. Yao, W. L. Jiang, J. T. Li, Q. J. Fu, Y. A. Li, Z. H. Liu, J. P. Ma, Y.
B. Dong, Inorg. Chem. 2017, 56, 2337-2344; c) M. S. Liu, L. Liang, X. Li,
X. X. Gao, J. M. Sun, Green Chem. 2016, 18, 2851-2863; d) Z. Z. Yang,
Y. N. Zhao, L. N. He, RSC Adv. 2011, 1, 545-567; e) X. P. Zhang, X. C.
Zhang, H. F. Dong, Z. J. Zhao, S. J. Zhang, Y. Huang, Energ. Environ.
Sci. 2012, 5, 6668-6681.
Typical procedures of cycloaddition of CO2 and epoxide.
[12] a) H. M. He, Q. Sun, W. Y. Gao, J. A. Perman, F. X. Sun, G. S. Zhu, B.
Aguila, K. Forrest, B. Space, S. Q. Ma, Angew. Chem. Int. Ed. 2018, 57,
4657-4662; b) B. Aguila, Q. Sun, X. L. Wang, E. O'Rourke, A. M. Al-
Enizi, A. Nafady, S. Q. Ma, Angew. Chem. Int. Ed. 2018, 57, 10107-
10111; c) P. Z. Li, X. J. Wang, J. Liu, J. S. Lim, R. Q. Zou, Y. L. Zhao, J.
Am. Chem. Soc. 2016, 138, 2142-2145.
All the cycloaddition reactions were conducted in a 70 mL
stainless steel reactor with a magnetic stirrer. Typically, a
mixture of P-Cm3Lm1Nm2 (0.39 mmol based on Br) and propylene
oxide (PO) (19.3 mmol) was added into a 70 mL stainless steel,
Then CO2 was charged in the reactor and adjusted to 1.2 MPa,
then the autoclave with magnetic a stirring bar was heated to
100 °C and stirred for 12 h. After the reaction was completed,
the autoclave was cooled to ambient temperature, and the
excess CO2 was vented. NMR was used to analyze the purity
and structure of the products using CDCl3 as the solvent. The
amount of all catalysts was calculated based on the fixed Br that
was verified by elemental analysis, as shown in Table S1.
[13] B. Chatelet, L. Joucla, J. P. Dutasta, A. Martinez, V. Dufaud, Chem. -
Eur. J. 2014, 20, 8571-8574.
[14] a) F. Huang, G. Lu, L. L. Zhao, H. X. Li, Z. X. Wang, J. Am. Chem. Soc.
2010, 132, 12388-12396; b) S. N. Riduan, Y. G. Zhang, J. Y. Ying,
Angew. Chem. Int. Ed. 2009, 48, 3322-3325; c) Y. Kayaki, M.
Yamamoto, T. Ikariya, Angew. Chem. Int. Ed. 2009, 48, 4194-4197.
[15] a) M. S. Liu, K. Q. Gao, L. Liang, F. X. Wang, L. Shi, L. Sheng, J. M.
Sun, Phys. Chem. Chem. Phys. 2015, 17, 5959-5965; b) W. G. Cheng,
B. N. Xiao, J. Sun, K. Dong, P. Zhang, S. J. Zhang, F. T. T. Ng,
Tetrahedron Lett. 2015, 56, 1416-1419; c) M. Alves, B. Grignard, S.
Gennen, R. Mereau, C. Detrembleur, C. Jerome, T. Tassaing, Catal.
Sci. Technol. 2015, 5, 4636-4643.
Recyclability Investigation for P-Cm3Lm1Nm2 Catalyst.
[16] a) S. Ghazali-Esfahani, H. B. Song, E. Paunescu, F. D. Bobbink, H. Z.
Liu, Z. F. Fei, G. Laurenczy, M. Bagherzadeh, N. Yan, P. J. Dyson,
Green Chem. 2013, 15, 1584-1589; b) W. G. Cheng, X. Chen, J. Sun, J.
Q. Wang, S. J. Zhang, Catal. Today 2013, 200, 117-124.
After the coupling reaction was completed, the recycled catalyst
was separated by centrifugation from the mixture and washed
with dichloromethane then used directly for the next run for
performance evaluation.
[17] a) K. Huang, J. Y. Zhang, F. J. Liu, S. Dai, ACS Catal. 2018, 8, 9079-
9102; b) S. Cai, D. L. Zhu, Y. Zou, J. Zhao, Nanoscale RES Lett. 2016,
11, 321; c) T. S. Nguyen, C. T. Yavuz, Chem. Commun. 2020.
[18] a) Y. Kayaki, M. Yamamoto, T. Ikariya, Angew. Chem. Int. Ed. 2009, 48,
4194-4197; b) H. Zhou, Y. M. Wang, W. Z. Zhang, J. P. Qu, X. B. Lu,
Green Chem. 2011, 13, 644-650.
Acknowledgements
[19] a) W. M. Ren, Y. Liu, X. B. Lu, J Org. Chem. 2014, 79, 9771-9777; b) X.
B. Lu, D. J. Darensbourg, Chem. Soc. Rev. 2012, 41, 1462-1484.
[20] a) W. L. Wang, C. Y. Li, L. Yan, Y. Q. Wang, M. Jiang, Y. J. Ding, ACS
Catal. 2016, 6, 6091-6100; b) Q. W. Song, Z. H. Zhou, L. N. He, Green
Chem. 2017, 19, 3707-3728.
This work was supported by the National Natural Science
Foundation of China (Grants 21674090, 21802030, 91956123
and 51973186).
Keywords: Carbon dioxide • Cyclic carbonates • Multifunctional
[21] a) D. J. Darensbourg, Inorg. Chem. Front. 2017, 4, 412-419; b) A.
Decortes, A. M. Castilla, A. W. Kleij, Angew. Chem. Int. Ed. 2010, 49,
9822-9837; c) C. X. Miao, J. Q. Wang, Y. Wu, Y. Du, L. N. He,
ChemSusChem 2008, 1, 236-241; d) J. Sun, L. Wang, S. J. Zhang, Z.
X. Li, X. P. Zhang, W. B. Dai, R. H. Mori, J. Mol. Catal. A-Chem. 2006,
256, 295-300.
organocatalyst • Heterogeneous catalysis • Thiol-ene click
References and notes
[1]
J. B. Zimmerman, P. T. Anastas, H. C. Erythropel, W. Leitner, Science
2020, 367, 397-400.
[22] a) H. Buettner, K. Lau, A. Spannenberg, T. Werner, ChemCatChem
2015, 7, 459-467; b) Z. L. Wu, H. B. Xie, X. Yu, E. H. Liu,
ChemCatChem 2013, 5, 1328-1333.
[2]
[3]
Y. Q. Zhu, C. Romain, C. K. Williams, Nature 2016, 540, 354-362.
T. P. Haider, C. Volker, J. Kramm, K. Landfester, F. R. Wurm, Angew.
Chem. Int. Ed. 2019, 58, 50-62.
[23] Y. M. Shen, W. L. Duan, M. Shi, Adv. Synth. Catal. 2003, 345, 337-
340.
[4]
[5]
J. M. Garcia, M. L. Robertson, Science 2017, 358, 870-872.
a) R. R. Shaikh, S. Pornpraprom, V. D'Elia, ACS Catal. 2018, 8, 419-
450; b) M. Aresta, A. Dibenedetto, A. Angelini, Chem. Rev. 2014, 114,
1709-1742; c) S. Gao, Y. Lin, X. C. Jiao, Y. F. Sun, Q. Q. Luo, W. H.
Zhang, D. Q. Li, J. L. Yang, Y. Xie, Nature 2016, 529, 68-71; d) X. B. Lu,
W. M. Ren, G. P. Wu, Accounts Chem. Res. 2012, 45, 1721-1735; e) S.
[24] X. F. Liu, Q. W. Song, S. Zhang, L. N. He, Catal. Today 2016, 263, 69-
74.
[25] a) M. S. Liu, X. Wang, Y. C. Jiang, J. M. Sun, M. Arai, Catal. Rev.-Sci.
Eng. 2019, 61, 214-269; b) J. Novacek, J. A. Izzo, M. J. Vetticatt, M.
Waser, Chem. -Eur. J. 2016, 22, 17339-17344; c) S. Y. Liu, N.
6
This article is protected by copyright. All rights reserved.