Photocatalytic Oxidation of Trichloroethylene
FULL PAPER
TiO2. Silicon wafers were dipped into the sol prepared from titanium(iv)
isopropoxide, and then exposed to a stream of NH3 for 5 min at 773 K in
a cylindrical tubular furnace.
[10] I. Tsuji, H. Kato, H. Kobayashi, A. Kudo, J. Am. Chem. Soc. 2004,
126, 13406–13413.
[11] S. U. M. Khan, M. Al-Shahry, W. B. Ingler, Jr., Science 2002, 297,
2243–2245.
[12] M. Anpo in Photocatalysis: Science and Technology (Eds.: M.
Kaneko, I. Okura), Kodansha, Tokyo, 2002, pp. 175–182.
[13] L. Zang, C. Lange, I. Abraham, S. Storck, W. F. Maier, H. Kisch, J.
Phys. Chem. B 1998, 102, 10765–10771.
[14] S. Sato, Chem. Phys. Lett. 1986, 123, 126–128.
[15] R. Asahi, T. Morikawa, T. Ohwaki, K. Aoki, Y. Taga,Science 2001,
293, 269–271.
[16] S. Sato, R. Nakamura, S. Abe, Appl. Catal. A 2005, 284, 131–137.
[17] M.-C. Yang, T.-S. Yang, M.-S. Wong, Thin Solid Films 2004, 469–
470, 1–5.
[18] H. Irie, Y. Watanabe, K. Hashimoto, J. Phys. Chem. B 2003, 107,
5483–5486.
[19] R. Nakamura, T. Tanaka, Y. Nakato, J. Phys. Chem. B 2004, 108,
10617–10620.
[20] Y. Sakatani, J. Nunoshige, H. Ando, K. Okusako, H. Koike, T.
Takata, J. N. Kondo, M. Hara, K. Domen, Chem. Lett. 2003, 32,
1156–1157.
Crystalline forms were ascertained by X-ray diffraction analysis (XRD;
Rigaku, Tokyo, Japan) before and after nitrogen doping. The optical
properties of the samples were measured with a UV/Vis spectrophotome-
ter (JASCO, Tokyo, Japan). X-ray photoelectron spectroscopy (XPS) was
used to characterize TiO2 surfaces doped and undoped with nitrogen.
Electron spin resonance (ESR; JEOL, Tokyo, Japan) was used to meas-
ure the changes in intensity and the extent of electron-hole pair forma-
tion under irradiation with visible light (l ꢁ430 nm; 500 W Hg lamp,
USH-500D); UV light was prevented from reaching the sample by
means of a colored glass filter (Y-43, Toshiba, Shizuoka, Japan).
Photocatalytic oxidation of TCE and analysis of the photoproducts ob-
tained from surface species: The cell used in the IR measurements con-
sisted of a cylindrical Pyrex glass batchwise reactor (60.5 mL) with IR-
transparent BaF2 windows at both ends. The visible-light-driven TiO2
photocatalysts and UV-driven TiO2 photocatalysts (ST-01) were used in
powder form to analyze the gas-phase photoproducts, while silicon
wafers coated with TiO2 (Si-TiO2ꢀXNX, Si-TiO2) were used to study the
reactions involving the adsorbed species.
[21] O. Diwald, T. L. Thompson, T. Zubkov, E. G. Goralski, S. D. Walck,
J. T. Yates, Jr., J. Phys. Chem. B 2004, 108, 6004–6008.
[22] a) L.-H. Zhao, S. Ozaki, K. Itoh, M. Murabayashi, Electrochemistry
2002, 70, 8–12; b) L.-H. Zhao, S. Ozaki, K. Itoh, M. Murabayashi,
Electrochemistry 2002, 70, 171–173 [in Japanese].
The visible-light source used was an HQI-TS/D250 W (total visible light
intensity = 5.6 mWcmꢀ2; Toshiba, Tokyo, Japan); an optical high-path
filter (l ꢁ 420 nm; Fuji Film, Tokyo, Japan) was used to cut out UV
light. The UV source used as a reference consisted of eight fluorescent
black light blue lamps (UV-BLB; total intensity
= ,
3.8 mWcmꢀ2
[23] P. B. Amama, K. Itoh, M. Murabayashi, J. Mol. Catal. B J. Mol.
Catal. A 2001, 176, 165–172.
FL20S.BLB, Toshiba, Tokyo, Japan) with a peak wavelength of 352 nm
(300–425 nm).
[24] H.-J. Nam, T. Amemiya, M. Murabayashi, K. Itoh, J. Phys. Chem. B
2004, 108, 8254–8259.
[25] M. R. Nimlos, W. A. Jacoby, D. M. Blake, T. A. Milne, Environ. Sci.
Technol. 1993, 27, 732–740.
[26] L. A. Dibble, G. B. Raupp, Catal. Lett. 1990, 4, 345–354.
[27] a) M. Murabayashi, Anzen Kogaku 2001, 40, 395–400 [in Japanese];
b) M. Murabayashi, Ceramics Japan 2004, 39, 515–518 [in Japa-
nese].
[28] M. R. Nimlos, W. A. Jacoby, D. M. Blake, T. A. Milne in Photocata-
lytic Purification and Treatment of Water and Air (Eds.: D. F. Ollis,
H. Al-Ekabi), Elsevier Science Publisher, New York, 1993, pp. 387–
392.
The gas-phase photoproducts formed during the photocatalytic oxidation
of TCE were analyzed by FT-IR spectroscopy (Perkin-Elmer Spectrum
GX FT-IR system; Nicolet 800 FT-IR spectrometer) and by gas chroma-
tography-mass spectrometry (GC/MS; Hewlett Packard 6890/5973, Hew-
lett Packard, Palo Alto, CA). An inspection tube (Gastec, Kanagawa,
Japan) was used to measure molecular chlorine (Cl2). Adsorbed species
on the surface of TiO2 (Si-TiO2ꢀXNX) were analyzed by means of in situ
FT-IR measurements after removal of the gas-phase species by purging
with dry air or N2. In addition, XPS was used for a quantitative analysis
of the adsorbate on the TiO2 after analysis of the surface species by FT-
IR.
[29] a) P. G. Blystone, M. D. Johnson, W. R. Haag in Air and Waste Man-
agement Association, 85th Annual Meeting, June 21st, 1992, Kansas
City, MO; b) P. G. Blystone, M. D. Johnson, W. R. Haag, P. F. Daley
in Emerging Technologies In Hazardous Waste Management III
(Eds.: D. W. Tedder, F. G. Pohland), ACS Symposium Series, 518,
American Chemical Society, Washington, DC, 1993, pp. 380–392.
[30] L. Bertrand, J. A. Franklin, P. Goldfinger, G. Huybrechts, J. Phys.
Chem. 1968, 72, 3926–3928.
Acknowledgements
The authors thank Mr. M. Kondo of the Instrumental Analysis Center,
Yokohama National University, and Mr. F. Sakamoto of Thermo Elec-
tron K. K. for help with the XPS measurements. The authors would also
like to thank Prof. Mikio Yagi, Yokohama National University, for help
with the ESR measurements.
[31] M. D. Driessen, A. L. Goodman, T. M. Miller, G. A. Zaharias, V. H.
Grassian, J. Phys. Chem. A 1998, 102, 549–556.
[32] J. Fan, J. T. Yates, Jr., J. Am. Chem. Soc. 1996, 118, 4686–4692.
[33] B. Karvaly, I. Hevesi, Z. Naturforsch. Teil A 1971, 26, 245–249.
[34] A. L. Linsebigler, G. Lu, J. T. Yates, Jr., Chem. Rev. 1995, 95, 735–
758.
[35] J. L. Gole, J. D. Stout, J. Phys. Chem. A 2004, 108, 1230–1240.
[36] Y. Nosaka in Photocatalysis: Science and Technology (Eds.: M.
Kaneko, I. Okura), Kodansha, Tokyo, 2002, pp. 69–85.
[37] Y. Nosaka, A. Nosaka, Nyumon Hikari Shokubai, Tokyo Tosho,
Tokyo, 2004, p. 72 (in Japanese).
[1] J. Kim, K. Itoh, M. Murabayashi, Denki Kagaku 1996, 64, 1200–
1202.
[2] M. Anpo, M. Takeuchi, Int. J. Photoenergy 2001, 3, 89–94.
[3] Y. Suda, H. Kawasaki, T. Ueda, T. Ohshima, Thin Solid Films 2004,
453–454, 162–166.
[4] S.-K. Joung, T. Amemiya, M. Murabayashi, K. Itoh, Surf. Sci., in
press.
[5] K. Hashimoto, T. Watanabe, K. Ishibashi, in Photocatalysis: Science
and Technology (Eds.: M. Kaneko, I. Okura), Kodansha, Tokyo,
2002, pp. 109–121.
[38] Y. Nakaoka, Y. Nosaka, J. Photochem. Photobiol. A 1997, 110, 299–
305.
[39] J. M. Coronado, A. J. Maira, J. C. Conesa, K. L. Yeung, V. Augu-
gliaro, J. Soria, Langmuir 2001, 17, 5368–5374.
[40] R. F. Howe, M. Grꢁtzel, J. Phys. Chem. 1987, 91, 3906–3909.
[41] O. I. Micic, Y. Zhang, K. R. Cromack, A. D. Trifunac, M. C. Thurna-
uer, J. Phys. Chem. 1993, 97, 7277–7283.
[6] Y. Xie, C. Yuan, Appl. Surf. Sci. 2004, 221, 17–24.
[7] T. Tachikawa, S. Tojo, M. Fujitsuka, T. Majima,J. Phys. Chem. B
2004, 108, 11054–11061.
[8] T. Ihara, M. Miyoshi, Y. Iriyama, O. Matsumoto, S. Sugihara, Appl.
Catal. B: Environ. 2003, 42, 403–409.
[42] A. R. Gonzꢂlez-Elipe, J. Soria, G. Munuera, Chem. Phys. Lett. 1978,
57, 265–268.
[9] T. Ohno, M. Akiyoshi, T. Umebayashi, K. Asai, T. Mitsui, M. Matsu-
mura, Appl. Catal. A 2004, 265, 115–121.
Chem. Eur. J. 2006, 12, 5526 – 5534
ꢀ 2006 Wiley-VCH Verlag GmbH & Co. KGaA, Weinheim
5533