16900-51-9Relevant articles and documents
Unusually sluggish copper(I)catalyzed oxidative dimerization of 2-ethynyl-1-methylpyrrole
Vasilevsky, S. F.,Verkruijsse, H. D.,Brandsma, L.
, p. 529 - 530 (1992)
Reaction of 2-ethynyl-1-methylpyrrole with oxygen in the presence of catalytic amounts of copper(I)chloride proceeds only upon addition of 1,8-diazabicycloundec-7-ene (DBU).
Stabilized Cu/Cu2O nanoparticles on rGO as an efficient heterogeneous catalyst for Glaser homo-coupling
Lu, Weiyang,Sun, Wei,Tan, Xiaofeng,Gao, Lingfeng,Zheng, Gengxiu
, p. 98 - 102 (2019)
Stabilized Cu/Cu2O nanoparticles on reduced graphene oxide (Cu/Cu2O-NPs@rGO) was synthesized by one-step co-reduction and acted as a green and efficient non-noble metal heterogeneous catalyst for Glaser homo-coupling. Through the synergic catalytic effect of Cu/Cu2O nanoparticles and graphene, the heterogeneous hybrid nanoparticles catalyst showed excellent catalytic performance for Glaser homo-coupling with the yield up to 99% of 1,4-diphenyl buta-1,3-diyne. And excellent functional group tolerance was obtained with oxygen as a green oxidant. Furthermore, the catalyst can be easily separated and recycled seven times without significant decline in its catalytic performance.
Copper(II) chloride-catalyzed Glaser oxidative coupling reaction in polyethylene glycol
Li, Yu-Nong,Wang, Jing-Lun,He, Liang-Nian
, p. 3485 - 3488 (2011)
Polyethylene glycol was shown to be an environmentally benign reaction medium for the copper(II) salt -catalyzed Glaser coupling reaction of terminal alkynes. In particular, oxygen as the sole oxidant worked very well for arylacetylenes even in short reaction time. The product was easily separated by extraction and the catalytic system could be reused four times without significant loss of reactivity.
CuCl-catalyzed green oxidative alkyne homocoupling without palladium, ligands and bases
Yin, Kun,Li, Chunju,Li, Jian,Jia, Xueshun
, p. 591 - 593 (2011)
CuCl-catalyzed green oxidative homocoupling of terminal alkynes produces symmetrical 1,4-disubstituted 1,3-diynes in good to excellent yields, using air as an environmentally friendly oxidant and the occurrence of water as exclusive byproduct in the whole process, and eliminating the need for ligands, bases, oxidants and expensive palladium catalysts. The Royal Society of Chemistry.
Synthesis and properties of 1,1′-bis(diacetylene-group) connected ferrocene-thiophene derivative: A cooperatively functional behavior of diacetylene-group connected constituents
Yoshino, Junro,Hasegawa, Emi,Hayashi, Naoto,Higuchi, Hiroyuki
, p. 4295 - 4298 (2011)
An extended π-electronic conjugation system of 1,1′- bis(diacetylene-group) connected ferrocene-thiophene derivative has been synthesized, with our integrated reaction between the corresponding TMS-protected acetylenes in one-pot. Its electronic properties have been examined, suggesting a cooperatively functional behavior of the diacetylene-group connected constituents.
Synthesis of 1,3-Diynes Using Calcium Carbide as an Alkyne Source
Liu, Zhenrong,Li, Zheng
, p. 302 - 308 (2020/12/11)
A simple method for the synthesis of 1,3-diynes from iodoarenes using calcium carbide as an alkyne source and air as an oxidant is described. A series of 1,4-diarylbuta-1,3-diynes were efficiently synthesized by this strategy. The salient features of this protocol are the use of inexpensive and easy-to-handle alkyne source, broad substrate scope, open-air condition, and simple operation procedure.
Aggregation induced emission-emissive stannoles in the solid state
Lork, Enno,Ramirez Y Medina, Isabel-Maria,Rohdenburg, Markus,Staubitz, Anne
supporting information, p. 9775 - 9778 (2020/09/07)
The optoelectronic and structural properties of six stannoles are reported. All revealed extremely weak emission in solution at 295 K, but intensive fluorescence in the solid state with quantum yields (ΦF) of up to 11.1% in the crystal, and of up to 24.4% (ΦF) in the thin film.