37571-88-3Relevant articles and documents
Influence of Na+ on DNA reactions with aromatic epoxides and diol epoxides: Evidence that DNA catalyzes the formation of benzo[a]pyrene and benz[a]anthracene adducts at intercalation sites
Fernando, Harshica,Huang, Chao-Ran,Milliman, Ann,Shu, Luchuan,LeBreton, Pierre R.
, p. 1391 - 1402 (2007/10/03)
Reactions of the benzo[a]pyrene (BP) and benz[a]anthracene (BA) metabolites, (±)-trans-7, 8-dihydroxy-anti-9, 10-epoxy-7, 8, 9, 10- tetrahydro-BP (BPDE), (±)-trans-3, 4-dihydroxy-anti-1, 2-epoxy-1, 2, 3, 4- tetrahydro-BA (BADE), (±)-BP-4, 5-oxide (BPO), and (±)-BA-5, 6-oxide (BAO), were examined under pseudo-first-order conditions at varying Na+ (2.0-100 mM) and native, calf thymus DNA (ctDNA) concentrations. In 0.2 mM ctDNA and 2.0 mM Na+, at a pH of 7.3, most BPDE, BADE, BPO, and BAO (87-95%) undergo DNA catalyzed hydrolysis or rearrangement. For BPDE and BPO, overall, pseudo- first-order rate constants, k, in 2.0 mM Na+ and 0.2 mM ctDNA are 21-72 times larger than values obtained without DNA. For BADE and BAO, the rate constants are less strongly influenced by DNA; k values in 0.2 mM ctDNA are only 9-12 times larger than values obtained without DNA. Kinetic data for BPDE, BPO, BADE, and BAO and DNA intercalation association constants (K(A)) for BP and BA diols which are model compounds indicate that K(A) values for BPDE and BPO in 2.0 mM Na+ are 6.6-59 times larger than those of BADE and BAO. The greater DNA enhancement of rate constants for BPDE and BPO, versus BADE and BAO, correlates with the larger K(A) values of the BP metabolites. DNA adducts, which account for less than 10% of the yields, also form. For BPDE in 0.20 mM ctDNA, k decreases 5.1 times as the Na+ concentration increases from 2.0 to 100 mM. Nevertheless, the DNA adduct level remains constant over the range of Na+ concentrations examined. These results provide evidence that, for BPDE in 0.20 mM DNA and 2.0 mM Na+, ctDNA adduct formation follows a mechanism which is similar to that for DNA catalyzed hydrolysis. The pseudo-first-order rate constant for adduct formation, k(Ad), given approximately by k(Ad) ? (k(cat, Ad)K(A)[DNA])/(1 + K(A)[DNA]), where k(cat, Ad) is a catalytic rate constant. For BADE, BPO, and BAO, the influence of varying DNA and Na+ concentrations on k values is similar to that for BPDE, and provides evidence that the formation of adducts follows the same rate law.
Photoemission probes of hydrocarbon-DNA interactions: A comparison of DNA influences on the reactivities of (±)-trans-7,8-dihydroxy-anti-9,10-epoxy-7,8,9,10-tetrahydrobenzo[a] pyrene, benzo[a]pyrene 4,5-oxide, and benz[a]anthracene 5,6-oxide
Urano, Shigeyuki,Price, Harry L.,Fetzer, Sharon M.,Briedis, Anita V.,Milliman, Ann,LeBreton, Pierre R.
, p. 3881 - 3893 (2007/10/02)
Time-resolved fluorescence and UV photoelectron measurements have been employed to examine the influence of calf thymus DNA on the reactivities of epoxides derived from benzo[a]pyrene (BP) and benz[a]anthracene (BA). By monitoring the increase in fluorescence intensity, which accompanies reaction at 23°C, overall, pseudo-first-order rate constants have been measured for reactions of the highly carcinogenic bay region epoxide (±)-trans-7,8-dihydroxy-anti-9,10-epoxy-7,8,9,10-tetrahydrobenzo[a]pyrene (BPDE) and of two less carcinogenic K region epoxides benzo[a]pyrene 4,5-oxide (BPO) and benz[a]anthracene 5,6-oxide (BAO). Overall rate constants for hydrolysis and rearrangement reactions have been measured for BPDE, BPO, and BAO in buffer alone (1.0 mM sodium cacodylate, pH 7.1). The rate constants increase in the order BPO ((3.8 ± 0.1) × 10-6 s-1) -5 s-1) -4 s-1). These results have been compared with overall rate constants for reactions, carried out in calf thymus DNA, which result in catalyzed hydrolysis and rearrangement, as well as DNA adduct formation. In DNA, the ordering of the rate constants for BPO and BAO changes from that observed in buffer alone. The rate constants increase in the order BAO ((2.8 ± 0.1) × 10-3 s-1) -2 s-1) -1 s-1). This ordering is the same as the ordering of association constants for the reversible binding to DNA of the fluorescent diols trans-7,8-dihydroxy-7,8-dihydro-BP (BP78D), trans-4,5-dihydroxy-4,5-dihydro-BP (BP45D) and cis-5,6-dihydroxy-5,6-dihydro-BA (BAD), which are model compounds of BPDE, BPO, and BAO, respectively. For the model compounds, the association constants for intercalation increase in the order BAD ((3.6 ± 0.9(× 102 M-1) 3 M-1) 4 M-1). This ordering is consistent with the ordering of the association constants of BPDE ((2.5 ± 0.3) × 104 M-1) and of BPO ((6.0 ± 1.0) × 103 M-1). The temperature dependence of the association constants of the model compounds demonstrates that, for the intercalation of the BP diols into DNA, differences in the enthalpy of binding contribute significantly to differences in the free energy of binding. UV photoelectron data and results from ab initio molecular orbital calculations on BPDE, BPO, and BAO indicate that, for these three epoxides, the association constants increase as the ionization potentials decrease and the polarizabilities increase. The percentage of epoxide reaction that yields DNA adducts has been compared under varying conditions. For long reaction times (>1 h) in systems containing native, calf thymus DNA at low salt concentrations, the ordering of adduct yields is BPO (14.9 ± 1.1%) > BPDE (10.1 ± 3.0%) > BAO (3.6 ± 0.4%). For short reaction times (10 min) in systems containing native DNA stabilized with 0.10 mM Mg2+, the ordering of adduct yields is BPDE (7.3 ± 1.9%) > BPO (1.3 ± 0.1%) > BAO (0.1 ± 0.1%). These results suggest that the ability of an epoxide to form adducts with exposed DNA during long reaction times is less indicative of the genotoxic potency of the epoxide than its ability to form adducts with stabilized DNA during short reaction times.