65679-81-4Relevant articles and documents
Indium(III) triflate promoted synthesis of alkyl levulinates from furyl alcohols and furyl aldehydes
Kean, Jacqueline R.,Graham, Andrew E.
, p. 175 - 179 (2015)
A facile protocol for the alcoholysis of furfuryl alcohol into levulinate esters has been developed employing low catalyst loadings of indium(III) triflate. This method provides a rapid and efficient route for the synthesis of these useful materials. The alcoholysis reactions of 5-hydroxymethylfurfural (HMF), furfural and furfural dimethylacetal were also investigated under these reaction conditions.
Catalytic Transfer Hydrogenation of Furfural to Furfuryl Alcohol by using Ultrasmall Rh Nanoparticles Embedded on Diamine-Functionalized KIT-6
Neeli, Chinna Krishna Prasad,Chung, Young-Min,Ahn, Wha-Seung
, p. 4570 - 4579 (2017/11/29)
A Rh/ED-KIT-6 catalyst comprised of Rh nanoparticles embedded on mesoporous silica (KIT-6) functionalized with N1-[3-(trimethoxysilyl)propyl]ethane-1,2-diamine was synthesized by Rh3+ adsorption and chemical reduction in the liquid phase. The structure of ED-KIT-6 and textural properties of the pristine and supported Rh catalysts, as well as particle size and chemical state of the Rh species were examined by various analytical methods. The homogeneous dispersion of ultrasmall Rh nanoparticles, approximately 1.2 nm in size, stabilized by the grafted diamine (ED) species was confirmed. Rh/ED-KIT-6 was applied to the transfer hydrogenation of furfural (FFR) to furfuryl alcohol (FAL) by using formic acid (FA) as the hydrogen source. The effect of the solvent and reaction parameters, such as temperature, reaction time, and FA/FFR ratio, were investigated. The Rh-embedded catalyst exhibited a significantly high turnover frequency (TOF≈204 h?1) to that of Ru, Pd, or Ni-based catalysts on KIT-6. A plausible reaction mechanism was proposed after examining an independent FA decomposition reaction over the same Rh-ED-KIT-6 catalyst. The heterogeneity of the catalyst was verified by a hot filtration experiment. The Rh/ED-KIT-6 could be reused for up to three cycles without any decrease in catalytic activity and selectivity, but the slow oxidation of Rh species was detected.
Effect of hydrogen donor on liquid phase catalytic transfer hydrogenation of furfural over a Ru/RuO2/C catalyst
Panagiotopoulou, Paraskevi,Martin, Nickolas,Vlachos, Dionisios G.
, p. 223 - 228 (2014/07/07)
The effect of alcohol hydrogen donor on methyl furan production through catalytic transfer hydrogenation of furfural in the liquid phase has been investigated over a mildly calcined Ru/C catalyst in the temperature range of 110-200 °C. It has been found that several parameters contribute to furfural hydrogenolysis, including alcohol dehydrogenation activity, solvent properties, as well as side reactions such as etherification between the intermediate, furfuryl alcohol, and the hydrogen donor. Methyl furan yield increases from 0 to 68% at 180 °C following the order of 2-methyl-2-butanol tert-butanol ethanol 1-propanol ～ 1-butanol 2-propanol 2-butanol ～ 2-pentanol, which correlates well with the alcohol dehydrogenation activity. In ethanol, 1-propanol, 2-propanol and 2-pentanol, furfuryl alcohol hydrogenolysis to methyl furan is significantly retarded at low temperatures due to furfuryl alcohol etherification with the corresponding alcohol solvent. We find that methyl furan yield decreases with increasing alcohol polarity. An optimum methyl furan yield of 76% is attained after 10 h of reaction at 180 °C, using 2-butanol and 2-pentanol as hydrogen donors. This is the highest reported yield in the liquid phase at temperatures below 200 °C.
