MATERIAL SAFETY DATA SHEET EPOXY TECHNOLOGY
14 FORTUNE DRIVE
PRODUCT NAME: EPO-TEK OG198 BILLERICA, MA 01821
Single Component
EMERGENCY PHONE:
*HMIS: HEALTH- 3 FIRE-1 REACTIVITY- 1 (978) 667 - 3805


Carcinogen: NTP (No) IARC (No) OSHA (No) DATE REVISED: 4/27/2006
* HMIS CODE ratings are estimated by Epoxy Technology. REV: B
____________________________________________________________________________________________
I. IDENTIFICATION & PHYSICAL DATA


PERCENT VOLATILE: NA VAPOR PRESSURE: NA
BOILING POINT: NA SOLUBILITY IN WATER: NA.
VAPOR DENSITY: NA EVAPORATION RATE: APPEARANCE: Orange Liquid SPECIFIC GRAVITY: NA
ODOR: Slight
____________________________________________________________________________________________
II. HAZARDOUS INGREDIENTS CAS# WT %


2,4,4 ?CTrihydroxy Triphenlymethane Triglycidyl Ether 66072-38-6 20%


2,4,4-Trihydroxy Triphenlymethane Triglycidyl Ether is the only hazardous ingredient that requires reporting per OSHA
Communication Standards, 29CFR 1910.1200.
_____________________________________________________________________________________________
III. FIRE & EXPLOSION DATA


FLASH POINT: >200 F
EXTINGUISHING MEDIA: Dry chemical, foam, carbon dioxide. Water may be ineffective.
UNUSUAL FIRE & EXPLOSION HAZARDS: Vapors may flow along surfaces to distant ignition sources and flash back. Closed
containers exposed to heat may explode.
SPECIAL FIRE FIGHTING PROCEDURES: Wear self contained breathing apparatus and complete personal protective equipment.
Remove all ignition sources. Use a water spray to cool fire exposed containers.
____________________________________________________________________________________________
IV. REACTIVITY DATA


STABILITY: Stable HAZARDOUS POLYMERIZATION: Will not occur.


CONDITIONS TO AVOID: Excessive heat, sources of ignition, flame. Direct sunlight will polymerize polymer.


MATERIALS TO AVOID: Strong acids or alkalies


HAZARDOUS DECOMPOSITION PRODUCTS: Fumes produced when heated to decomposition may include carbon monoxide,
and carbon dioxide.
____________________________________________________________________________________________
The information and recommendations contained in this msds have been compiled from sources believed to be reliable and to
represent the most reasonable current opinion on the subject when the msds was prepared. No warranty, guarantee, or
representation is made as to the correctness or sufficiency of the suffiency of the information. The user of this product must decide
what measures are necessary to safely use this product, either alone or in combination with other products, and to determine its
environmental regulatory compliance under applicable federal or state laws.
V. HEALTH HAZARD DATA EPO-TEK OG198


EFFECTS OF OVER EXPOSURE


INGESTION: No specific information available.
INHALATION: Prolonged breathing of vapor may be irritating and may cause nausea and vomiting.
SKIN CONTACT: Can cause dermatitis.
EYE CONTACT: Irritating to the eyes. Can cause injury.
CHRONIC EFFECTS OF OVER EXPOSURE: Combinations of the above conditions can
be experienced.


EMERGENCY & FIRST AID PROCEDURES


EYE CONTACT: In case of eye contact, flush with water for at least 15 minutes.
Get medical attention immediately.
SKIN CONTACT: In case of skin contact, clean with soap and water. Do not use
solvents. Remove contaminated clothing.
INGESTION: Get medical attention immediately.
INHALATION: Remove employee to fresh air. If discomfort persists, get medical
attention.
____________________________________________________________________________________________
VI. SPILL OR LEAK PROCEDURES


STEPS TO BE TAKEN IN CASE MATERIAL IS SPILLED: Eliminate ignition
sources. Use eye and skin protection. Place leaking containers in a well ventilated area.
Absorb spillage with inert material and dispose. Wear self- contained breathing
apparatus.
WASTE DISPOSAL METHOD: Incinerate or use hazardous waste treatment
procedures that are in accordance with federal, state and local regulations. Do not
discharge into natural water sources.
____________________________________________________________________________________________
VII. SPECIAL PROTECTION INFORMATION


RESPIRATORY PROTECTION: Wear an NIOSH approved respirator for organic
vapors whenever high level exposure to vapors or mist is anticipated in confined area.
VENTILATION: Locale exhaust recommended for exposure control.
PROTECTIVE GLOVES: Impervious gloves - neoprene or equivalent. A combination
of barrier cream and gloves is recommended.
EYE PROTECTION: Chemical splash goggles recommended.
OTHER PROTECTIVE EQUIPMENT: For operations where contact can occur, use a
face shield and impervious apron. A safety shower and eye wash facility should be
available.
____________________________________________________________________________________________
VIII. SPECIAL PRECAUTIONS: Avoid contact with skin and eyes. Avoid breathing vapors. Keep containers closed when not
in use. Remove all contaminated clothing immediately and wash. Wash skin thoroughly with soap and water after
handling. Solvents should not be used to clean skin because of increased penetration potential - protective skin oils can
be dissolved by solvents.
REGULATORY INFORMATION EPOXY TECHNOLOGY
14 FORTUNE DRIVE
BILLERICA, MA 01821
PRODUCT NAME: EPO-TEK OG198 TEL: (978) 667-3805
DATE REVISED: 4/27/2006
REV: B

SARA TITLE III SECTION 313 SUPPLIER NOTIFICATION

This product contains the following toxic chemicals subject to the reporting requirements of Section 313 of the Emergency Planning
and Community Right To Know Act of 1986 (40 CFR 372): None


1. TSCA Inventory Status

All the components of this product are listed on the TSCA Inventory.

2. RCRA Status

This product contains the following chemicals listed on the 40 CFR Part 261.33: None

3. CERCLA Status

This product contains the following chemicals listed on the 40 CFR Part 302.4: Acetic acid

4. Transportation


Not Restricted


______________________________________________________________________________________
The information contained herein is given in good faith. However, no guarantee or warranty of any kind expressed or implied is
made with respect to this information.


TRIPHENYLOLMETHANE TRIGLYCIDYL ETHER