TECH LINE COATINGS, INC.


26844 ADAMS AVE. MURRIETA, CA 92562 Phone 951-304-0498
Fax 951-461-9658
www.techlinecoatings.com

MATERIAL SAFETY DATA SHEET
SECTION I
PRODUCT IDENTIFICATION This product contains ingredients on both CEPA DSL and TSCA inventory
COMMON NAME(S): IC-1
CHEMICAL NAME: N/A
CHEMICAL FAMILY: COMPLEX MIXTURE
INFORMATION PHONE: 951-304-0498
EMERGENCY
CALL CHEMTREC (800) 424-9300
DATE PREPARED: 7/04/01

SECTION II
HAZARDOUS INGREDIENTS
NAME CAS NUMBER CONCENTRATION

LIGNOSULFONIC ACID 68512-34-5 >1%
TLV TWA : 15 MG/CU M
TLV STEL: N/E
OSHA PEL: 15 MG/CU M

ZINC COMPOUND PROPRIETARY
TLV TWA : 10PPM
TLV STEL: 10PPM
OSHA PEL: 10 MG/CU M

(2-BENZOTHIAZOLYLTHIO) BUTANEDIOIC ACID 95154-01-1 >5%
TLV TWA : N/E
TLV STEL: N/E
OSHA PEL: N/
2-METHOXYMETHYLETHOXYPROPANOL (DPM) 34590-94-8 >1%
TLV TWA : 100PPM
TLV STEL: 150PPM
OSHA PEL: 100PPM

ALCOHOLS, TALLOW, ETHOXYLATED 61791-28-4 >1%
TLV TWA : N/E
TLV STEL: N/E
OSHA PEL: N/E

2,2,4- TRIMETHYL - 1, 3 - PENTANEDIOL 025265-77-4 <5%
MONOISOBUTYRATE
TLV ACGIH: N/E
OSHA PEL: N/E

2-AMINO-2-METHYL-1-PROPANOL 124-68-5 >1%
2-(METHYLAMINO)-2-METHYL-1-PROPANOL 27646-80-6 >1%

RESIN and Certain Fillers Trade secret

(There are no SARA 313 chemicals in this resin)
SECTION III
PHYSICAL PROPERTIES
BOILING POINT: 286F.
VAPOR DENSITY (AIR = 1): <1
% VOLATILE VOLUME: <50%
APPEARANCE AND ODOR: GRAY/BLACK, MILD SOLVENT SMELL
SOLUBILITY IN WATER: APPRECIABLE
VOC??S: >1.35 LBS/GAL (less water)


SECTION IV
FIRE AND EXPLOSION DATA
FLASH POINT: 188F
DOT: FLAMMABLE LIQUI EXTINGUISHING MEDIA: Carbon Dioxide, Dry Chemical, Foam

SPECIAL FIRE FIGHTING PROCEDURES: Wear Self Contained Breathing Apparatus. Cool exposed containers with water spray

UNUSUAL FIRE AND EXPLOSION HAZARDS: Burning pigments could release hazardous fumes.

SECTION V
REACTIVITY DATA
STABILITY: Stable
INCOMPATIBILITY (MATERIALS TO AVOID): Strong Oxidizing Agents. Water reactive materials
HAZARDOUS POLYMERIZATION: Will Not Occur
SECTION VI
HUMAN HEALTH DATA
ROUTES OF ENTRY:
INHALATION: YES
SKIN: YES
INGESTION: YES
CARCINOGENICITY: Contains ingredients which may cause cancer based on animal data. Risk of cancer depends on duration and level of exposure.
HEALTH HAZARDS:
EYES: Repeated or prolonged eye contact may be irritating.
SKIN: Repeated or prolonged eye contact may be irritating.
INHALATION: Harmful if inhaled. May cause respiratory irritation, dizziness, headache, and nausea.
INGESTION: Overexposure to the ingredients may cause irritation to the gastrointestinal tract,
EMERGENCY AND FIRST AI EYES: Flush immediately with water for at least 15 minutes, get medical attention.
SKIN: Remove contaminated clothing. Wash thoroughly all exposed skin with soap and water.
INHALATION: Remove to fresh air, give artificial respiration if necessary, get medical attention.
INGESTION: DO NOT INDUCE VOMITING, Get medical attention.
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE: Any respiratory or skin condition.

SECTION VII
SPILL OR LEAK PROCEDURES
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Ventilate area, Avoid breathing of vapors, wear protective equipment. Dike and
contain spill, pump into salvage tank or absorb with suitable material. Eliminate all sources of ignition.
WASTE DISPOSAL METHOD: Dispose of in accordance with applicable local, municipal, state and federal regulations.

VIII. SPECIAL PROTECTION/CONTROL MEASURES
RESPIRATORY PROTECTION: Maintain below Pel / Tev. Wear NOISHA/MSHA approved respirator
VENTILATION: Local exhaust recommended
LOCAL EXHAUST: Use Non Sparking
MECHANICAL: Use Non Sparking
PROTECTIVE GLOVES: Chemical resistant rubber gloves
EYE PROTECTION; Safety goggles/glasses recommended
OTHER PROTECTIVE EQUIPMENT: Clean long legged/sleeved work clothes
WORK/HYGENIC PRACTICES: Use in accord with good industrial work and hygiene safety practices. Always wash with soap and water before eating, smoking
or handling food or food related equipment/utensils
.
SECTION IX
SPECIAL PRECAUTIONS

HANDLING AND STORAGE: Keep container closed when not in use. Avoid skin or eye contact. Avoid prolonged breathing of mists,dusts or vapors. Avoid heat,
flame or other sources of ignition. Take precautionary measures against static discharge. handle as an industrial chemical.
STORAGE TEMPERATURE: Do not store at temperatures above 85f. Suitable storage should be provided in accord with OSHA regulation 1910. 106. Empty
containers may contain product residue including flammable or explosive vapors. Do not cut, do not cut, puncture or weld on or near this container.

THIS INFORMATION IS FURNISHED WITHOUT WARRANTY, REPRESENTATION, INDUCEMENT OR LICENSE OF ANY KIND, EXCEPT THAT IT
IS ACCURATE TO THE BEST OF TECH LINE COATINGS, INC., KNOWLEDGE OR OBTAINED FROM SOURCES BELIEVED BY TECH LINE
COATINGS, INC., TO BE ACCURATE, AND TECH LINE COATINGS, INC., DOES NOT ASSUME ANY LEGAL RESPONSIBILITY FOR USE O RELIANCE UPON SAME. BEFORE USING ANY CHEMICAL READ ITS LABEL, INSTRUCTIONS AND MATERIAL SAFETY DATA SHEET.






1-Propanol, 2-methyl-2-(methylamino)-