Mixed Oxides of Hydrotalcites as Catalysts for NOPOL (cas 128-50-7) Epoxidation

Add time:10/01/2019    Source:infona.pl

Mixed oxides catalysts derived from Mg/Al hydrotalcite-type materials with molar ratios of 1, 2, 3 and 4 were synthesized, characterized and tested in NOPOL (cas 128-50-7) epoxidation. A combined oxidant of hydrogen peroxide and acetonitrile was used in the presence of acetone and water as solvents. Catalysts were characterized by X-ray diffraction (XRD), N2 adsorption, scanning electron microscopy (SEM), atomic absorption spectrophotometry (AAS), basicity by CO2-TPD, and infrared spectroscopy (FTIR). SEM analysis showed in all materials irregular non-homogeneous aggregates. Basicity of mixed oxides increased with Mg/Al ratio. The effect of temperature and basicity of the catalysts on the catalytic activity was analyzed. The best conversion and selectivity were obtained (60 °C, 2 h) over the most basic catalyst HT4C (mixed oxide Mg/Al = 4), with 99% conversion, epoxide selectivity of 38% and a selectivity of 36% to a campholenic aldehyde analogue compound, which duplicate the activity reported over a heterogeneous catalyst based on askanite–bentonite solid starting from nopol epoxide. In terms of TOF the most active catalyst, which also combines an acceptable conversion, was mixed oxide HT3C (mixed oxide Mg/Al = 3). Graphical

We also recommend Trading Suppliers and Manufacturers of NOPOL (cas 128-50-7). Pls Click Website Link as below: cas 128-50-7 suppliers

Prev:Transformations of epoxide derived from NOPOL (cas 128-50-7) over askanite-bentonite clay
Next:Dynamic parameter estimation and identifiability analysis for heterogeneously-catalyzed reactions: Catalytic synthesis of NOPOL (cas 128-50-7))