563-45-1 Usage
Chemical Properties
Colorless, extremely volatile liquid or
gas; disagreeable odor.Soluble in alcohol; insoluble in water.
Physical properties
Colorless, flammable liquid or gas with a disagreeable odor
Uses
Different sources of media describe the Uses of 563-45-1 differently. You can refer to the following data:
1. 3-Methyl-1-butene has been used in asymmetric total synthesis of (?)-Linderol A, a potent inhibitor of melanin biosynthesis of cultured B-16 melanoma cells.
2. Organic synthesis, high-octane fuel manufacture.
Definition
ChEBI: An alkene that is but-1-ene carrying a methyl substituent at position 3.
General Description
A colorless volatile liquid with a disagreeable odor. Insoluble in water and less dense than water. Vapors heavier than air. Flash point below 0°F. Used to make other chemicals.
Air & Water Reactions
Highly flammable. Insoluble in water.
Reactivity Profile
3-Methyl-1-butene may react vigorously with strong oxidizing agents. May react exothermically with reducing agents to release hydrogen gas. In the presence of various catalysts (such as acids) or initiators, may undergo exothermic addition polymerization reactions.
Hazard
Highly flammable, dangerous fire and
explosion risk, explosive limits 1.6–9.1%.
Health Hazard
Inhalation or contact with material may irritate or burn skin and eyes. Fire may produce irritating, corrosive and/or toxic gases. Vapors may cause dizziness or suffocation. Runoff from fire control or dilution water may cause pollution.
Safety Profile
Very dangerous fire
hazard when exposed to heat, flame, or
oxidizers. Explosive in the form of vapor
when exposed to heat or flame. To fight
fire, use alcohol foam, mist, spray, dry
chemical, CO2. When heated to
decomposition it emits acrid smoke and
irritating fumes. See also 2-METHYL-1
BUTENE.
Source
Schauer et al. (1999) reported 3-methyl-1-butene in a diesel-powered medium-duty truck
exhaust at an emission rate of 160 μg/km.
Schauer et al. (2001) measured organic compound emission rates for volatile organic
compounds, gas-phase semi-volatile organic compounds, and particle-phase organic compounds
from the residential (fireplace) combustion of pine, oak, and eucalyptus. The gas-phase emission
rate of 3-methyl-1-butene was 6.9 mg/kg of pine burned. Emission rates of 3-methyl-1-butene
were not measured during the combustion of oak and eucalyptus.
California Phase II reformulated gasoline contained 3-methyl-1-butene at a concentration of 380
mg/kg. Gas-phase tailpipe emission rates from gasoline-powered automobiles with and without
catalytic converters were 0.35 and 22.5 mg/km, respectively (Schauer et al., 2002).
Environmental fate
Photolytic. The following rate constants were reported for the reaction of 3-methyl-1-butene and
OH radicals in the atmosphere: 3.0 x 10-11 cm3/molecule?sec (Atkinson et al., 1979); 6.07 to 9.01 x
10-11 cm3/molecule?sec (Atkinson, 1985); 3.18 x 10-11 cm3/molecule?sec (Atkinson, 1990).
Chemical/Physical. Complete combustion in air yields carbon dioxide and water.
Check Digit Verification of cas no
The CAS Registry Mumber 563-45-1 includes 6 digits separated into 3 groups by hyphens. The first part of the number,starting from the left, has 3 digits, 5,6 and 3 respectively; the second part has 2 digits, 4 and 5 respectively.
Calculate Digit Verification of CAS Registry Number 563-45:
(5*5)+(4*6)+(3*3)+(2*4)+(1*5)=71
71 % 10 = 1
So 563-45-1 is a valid CAS Registry Number.
InChI:InChI=1/C5H10/c1-4-5(2)3/h4-5H,1H2,2-3H3
563-45-1Relevant articles and documents
-
Yokoyama
, p. 2975 (1970)
-
-
Nakano,Y. et al.
, p. 2833 - 2836 (1972)
-
-
Taylor,Simons
, p. 453,455,459,462 (1971)
-
CATALYTIC HYDROCARBON DEHYDROGENATION
-
Paragraph 0056; 0122; 0123, (2021/03/13)
A catalyst for dehydrogenation of hydrocarbons includes a support including zirconium oxide and Linde type L zeolite (L-zeolite). A concentration of the zirconium oxide in the catalyst is in a range of from 0.1 weight percent (wt. %) to 20 wt. %. The catalyst includes from 5 wt. % to 15 wt. % of an alkali metal or alkaline earth metal. The catalyst includes from 0.1 wt. % to 10 wt. % of tin. The catalyst includes from 0.1 wt. % to 8 wt. % of a platinum group metal. The alkali metal or alkaline earth metal, tin, and platinum group metal are disposed on the support.
Dendrimer-Encapsulated Pd Nanoparticles, Immobilized in Silica Pores, as Catalysts for Selective Hydrogenation of Unsaturated Compounds
Karakanov, Edward A.,Zolotukhina, Anna V.,Ivanov, Andrey O.,Maximov, Anton L.
, p. 358 - 381 (2019/04/04)
Heterogeneous Pd-containing nanocatalysts, based on poly (propylene imine) dendrimers immobilized in silica pores and networks, obtained by co-hydrolysis in situ, have been synthesized and examined in the hydrogenation of various unsaturated compounds. The catalyst activity and selectivity were found to strongly depend on the carrier structure as well as on the substrate electron and geometric features. Thus, mesoporous catalyst, synthesized in presence of both polymeric template and tetraethoxysilane, revealed the maximum activity in the hydrogenation of various styrenes, including bulky and rigid stilbene and its isomers, reaching TOF values of about 230000 h?1. Other mesoporous catalyst, synthesized in the presence of polymeric template, but without addition of Si(OEt)4, provided the trans-cyclooctene formation with the selectivity of 90–95 %, appearing as similar to homogeneous dendrimer-based catalysts. Microporous catalyst, obtained only on the presence of Si(OEt)4, while dendrimer molecules acting as both anchored ligands and template, demonstrated the maximum activity in the hydrogenation of terminal linear alkynes and conjugated dienes, reaching TOF values up to 400000 h?1. Herein the total selectivity on alkene in the case of terminal alkynes and conjugated dienes reached 95–99 % even at hydrogen pressure of 30 atm. The catalysts synthesized can be easily isolated from reaction products and recycled without significant loss of activity.